Understanding the Settings Page on the Analytics Portal

The settings page can be accessed by clicking on the last tab located at the top right of the page named 'Settings.' 

Here you have control over the following parameters:

• Location: allowing you to switch between weather locations available within the sites you have access to. Location can also be changed directly from each weather condition page
• Dates: allowing you to set a start and end date window which you'd like all pages to focus on, as well as the interval the data is displayed in. Note that the 'raw' interval refers to 15 minute data and is not available from all data sources. These date settings can also be changed directly from each weather condition page
• Display: allowing you to show or hide the map and wind direction arrows on charts where applicable
• Growing Degrees Threshold: allowing you to accept the default GDD threshold or amend it as desired for your particular crop type, making sure that if you are using a custom threshold, you select 'yes' to override the default and set your required number. This will then alter the data displayed in the GDD chart and table column
• Chill Hour Threshold: allowing you to accept the default Chill Hour threshold or amend it as desired for your particular crop type, making sure that if you are using a custom threshold, you select 'yes' to override the default and set your required number. This will then alter the data displayed in the Chill Hour chart and table column